How to install the NAT service using the Routing And Remote Access Server Setup Wizard

1. Click Start, Administrative Tools, and then click Routing and Remote Access to open the Routing and Remote Access management console.

2. In the left console pane, select the RRAS server that you want to work with.

3. From the Action menu, click Configure and Enable Routing and Remote Access.

4. The Routing and Remote Access Server Setup Wizard initiates.

5. Click Next on the Routing and Remote Access Server Setup Wizard welcome page.

6. On the Configuration page, select the Network Address Translation (NAT) option, and then click Next.

7. On the NAT Internet Connection page, you have to select the connection method which NAT will use to connect to the Internet:

• Use this public interface to connect to the Internet option.

• Create a new demand-dial interface to the Internet option.

8. If you want to enable NAT security, leave the Enable security on the selected interface by setting up Basic Firewall option selected. The option is enabled by default. Click Next.

9. On the Ready to Apply Selections page, click Next.

10. Click Finish.

1

11. Click Yes to start the Routing and Remote Access service.